+90212 2109565

Servo Valve Amplifier Card

In the past the servo valves was very popular on pressbrake upper table control.

The controllers was capable to drive these servo valves directly.

Nowadays proportional valves are used in pressbrakes.

That’s why modern CNC controllers don’t drives servo valves directly.

If your pressbrake cnc controller break down you must use a modern cnc controller.

So there is a need to use an interface in between cnc controllers and servo valves.

In the market there are moog and schneider brand servo valves.

We offer one solution for all types. The servo valve amplifer can be used for both moog and schneider servo valves.

Please contact with us for more information and inquiry.

You can download datasheet below:

MOOG-SCHNEIDER Board Datasheet

Related Post

RF-BVK-S1 Pressure Valve Amplifier Module

Pressure valve module is used on press brakes to create pressure. This is a converter board, adjusting valve output current in a range 0-1 Amper depending control signal at analog

Retrofitting Press Brake Controller

Whatever the brand of your broken pressbrake we have retrofit solution for controllers. Repairing of broken CNC controllers can be too expensive and long down time for your pressbrake. We

DU 6000 RETROFIT

DU 6000 are produced by Cybelec SA as a customized product for Durmazlar. DU-6000 is based on DNC60PS controller but it has larger screen than DNC60PS. Cybelec SA company stopped